Search found 828 matches
Rather than make a two section stock as per original, I opted for a one piece because of strength and of course ease of manufacture, I will recess the band area, and fashion a two piece metal band from a thinner piece of sheet, this will be easier to form. I’ve done this before and the result is goo...
You are correct Anu, G3 receiver, top and bottom, shaved a few bits off here and there, so it still breaks down very much the same as any G3, just have to remove cylindrical mag tins to expose G3 pins. The mags are standard CYMA 200 rnd mid caps, could be widened to look a bit better, with foam Rubb...
I must admit quite a strange one to do, but it was fun doing it, the hop unit is made from a kitchen cutting board! Using the original hop as well, with a piece of M4 hop. The originals were only used in the Pacific I believe, but were well received by the Marines. The colour does look bright in the...
- Fri Jul 03, 2020 6:46 pm
- Forum: General WW2 Airsoft Discussion
- Topic: in need of help
- Replies: 3
- Views: 276
Ukara is only to cover complete Airsoft guns, It’s not needed for parts, that’s one of the stupid parts of the ruling you could order a complete gun in parts and not need a ukara registration.....would work out a bit expensive though!