agm mp40 trigger block/switch

A place to discuss WW2 airsoft guns.
Stanley
Veteran
Veteran
Posts: 111
Joined: Sat Jan 10, 2015 10:38 pm
Location: Redditch, W.Mids

Re: agm mp40 trigger block/switch

Postby Stanley » Fri Aug 19, 2016 6:58 am

Think it's sorted for final attempt tonight.
Hadn't occurred to me that the cylinder head could have moved in the cylinder - probably when cleaning the crud out.
So the cylinder was that bit too far back and fouling the sector gear.
Will have to reshim as had moved bushings around to see if that made any diff.

Thank you Raffles and Dadio for the pointers and explanations....think I will get there tonight

:good:
ImageImageImage
ImageImageImage
Image
Lord Elpus
Fought at the Somme
Fought at the Somme
Posts: 959
Joined: Fri Sep 16, 2016 9:48 pm

Re: agm mp40 trigger block/switch

Postby Lord Elpus » Wed Sep 21, 2016 11:44 am

Just been through this with my mp40, contacts just weren't contacting on occasion, really annoying. Got an shs trigger switch but it didn't fit too wide..........it fits now! A light touch of a small file here and there and it went in eventually.
I've gone down the mosfet route, no more burnt contacts, should have had a slight increase in rof, but at the moment I've only got an11.1v lipo to fit in the space with the mosfet.......a little too much on the rof! It's running 780rpm according to my chrono, waiting for the postie to deliver a 7.4 lipo, that should then slow it down again, if not I will change the mosfet for a programmable one.
Image Image Image Image Image Image Image Image Image Image Image Image Image Image Image

Return to “WW2 Airsoft Weapons”

Who is online

Users browsing this forum: No registered users and 2 guests