ITEM:Hudson M3A1 Grease Gun
FPS: 290-310 on Propane / Green Gas.
CONDITION: Good
ACCESSORIES: 3 Mags (can inclue 3 cell pouch)
SWAPS: yes King Arms Thompson, TM Thompson, PPSH possibly. Sten
SPLITS: yes (dependant on sale of other parts)
COST: £200 (negotiable of course)
LOCATION: Hemel Hempstead.
DELIVERY METHOD: You can choose!
DELIVERY COST: £10.00 approx recorded delivery
PAYMENT: cheque ~ paypal ~ cash
SEND OVERSEAS: yes
EXTRA INFO:
It is with much regret that i must put up for sale my Hudson M3A1Grease Gun. It has done approx 3k Rounds through it and all the intrenals are in quite good nick. (except for the broken part! 
) It comes with the standard recoil springs and the Hidakaya Recoil Spring's. KM 6.04mm barrel as well as the original. Comes with 3 leak free mags (all held gas at anarchy no problem) but will be tested again before shipping. Can include a grease gun 3 cell ammo pouch, (repro) which actually fit the mags. (Lots of other repro's arnt big enough it seems as they are all measured against thompson mags!) I originally brought a Grease Guns one from WW2 Guns this didnt came so as I was trying to get a claim put through against them. So i ordered one from WGC and both came the same week a couple of weeks later. How ever both came to me with broken barrels! I have refixed them with some tough bonding agent and both have never come off, although this is something that you might want to look into at some point. I am just trying to be as honest about the gun as possible.
Below is a pic of all the bits you can get. Please note sling is not part of the deal.
This is a picture of the wear caused by the recoil parts. The plate should be straight and the screw is slightly off centre. But these parts still work fine. Again i am trying to be honest as possible with my assesments.
This next picture is of the broken part. There should be an Arch or an O around the bar. This is the part which broke at Anarchy when i fired it in the boiling heat. (But lovely recoil 
) You could potentially work around this if you have some of the skills like Dadio, Jay, Rifleman etc. The gun will still cock and dry fire a single round. How ever instead of staying on the runners the whole bolt goes off centre and then you will have to dismantle the gun and reset it all for it to work. Possibly increasing the thickness of the plate shown above will give less recoil distance and increase the RPS (a bit like the Shoei MG 42 mod) this however works on the basis that it stops the bolt going back too far thus keeping it on the runners.
The last picture is just the wear which you get when the nozzle kisses the mag and takes the gas in. This is the part which alot of Hudsons break but mine however is still very usable.
Or if your just after a gun which you want to try out some AEG skills on there is a guide of using a Mac 11 or Mp7 gearbox although i am sure other types will fit. I am willing to split parts of the gun, but this is based on the sales of other parts. If you got any questions feel free to contact me. 
Stu
Sold!
