hi guys,
right i just gone thru all my mp40 low caps and 3 out of the 8 are mis-feeding. can this be fix to stop the mis feeding?
what they do is shoot around 20 rounds out then stop feeding them.
any help much appreciated.
leigh
Hi ya mate, the only thing i can suggest is to squirt some silicon spray down the feed mechanism, I.E into the mag 
you can get it from most airsoft shops.
A little tip try not to fill the mags up to there full capacity, thus compressing the spring all the way, it tends to make the mag spring weak, and most of all never leave the mags sprung I.E never leave bb's in them, again it will weaken the spring, always empty them after you have finished.
hope this helps
Ady.
I had the same problem with my MP40 mags. The cure I found is similiar to what adrainlap suggetsted. I squirted a small amount of silicone down into each mag. I then 'rodded' each mag with the cleaning rod with a bit of kitchen towel attached to soak up the silicone. I believe this 'freed' up the feed and also got rid of any rough edges in the feed tube. Worked a treat for me.
Good luck
Regards
'shokt
"The older I grow the more I distrust the familiar doctrine that age brings wisdom"
H.L.Mencken
If you have still got sand in them lurking from D Day that doesn't help either, that was what effected mine, as it was so fine 
______________
cheers guys did what you said and 2 work fine now but one is still a bit iffy. bloody sand but worth it for the d-day experience.
cheers again
loc
I've had the same problems but luckily the MP40 mags are a doddle to strip down... Just knock the base plate off, slip out the internals and you can get the spring out and clean and oil the internals in about two minutes.
i give that ago tonight on that iffy one. if it breaks oh well lol
cheers bud
