Today I finished the lower receiver and made up the sling points ,the sling points were quite hard to do ,while its easy with a blow torch ,3mm mild s...

What I can't get over is how natural the sights feel now I have the stock on it ,all the way through the build I've been holding it up trying to see h...

This is really near completion now ,just have to cut out a section of the lower receiver on the left side below the sling point ,a fake screw in the b...

Thats very nice work ,well done !

the stock is finished including the catch .

The hop is what stops the bb rolling out of the barrel ,with it fully off it does not hold the bb back so it will roll out ,the way it works is by pro...

I like this one, captions please... Someone Google the instruction manual ,have you try'd shutting it down and re starting it ?

started the stock today ,feels nice to shoulder and the sights don't feel too odd either .

Two German slot's have opened up ,get em while they're hot !

You could just buy two no4 sling mounts ,they aren't expensive and would look the part on the box.

thats as compact as i can make it ,it mostly fits in the space above the motor ,i've test fitted it with the battery and lipo alarm and it all fits , ...

I've been tinkering around with this all afternoon and I think I have a solution to the codking handle ,at the front of the slot I have a guide block ...

i know you expect to see the spring but you don't ,never in any picture ,the spring was quite narrow as you can see in the picture below and was deep ...

The action has probably just worn inn ,most gun's are a little tight straight out of the box and loosen up a bit with use.

does it still fire? if the cylinder head came unscrewed it could feel like this but it would not fire .