That box looks rather familiar , I'm sure its nearly there .

Just take care of her and we'll see you at the next one.

should be a good crowd !

Shapeways has them to 3d print to order £8.25 even has them listed as King Arms Thompson

all i one piece and working , just need to do the mags and sight leaf.

Filled , rubbed down and paint going on .

Fixed the gearbox , it was just the pinion gear on the motor stripped , the adjuster screw for the motor was wound all the way out and had obviously ...

I now have a final version of the hop unit and I'm just printing what I hope will be the finished mag well liner . These parts will be for sale soon i...

If you can send me an STL file I'll happily print it for you as that's pretty easily done , I didn't mean to teach you to suck eggs .

This is great stuff! Maybe I’ll have to commission you to make some Sten type hop units, as the originals of those are pretty pony, as well. Also want...

I was going to start filling and sanding today when i realized I'd forgotten the rear sight , I'd already 90% finished it so it only took a little whi...

I've got stuff from the above mentioned ABZ airsoft but I remember it was expensive ( could be wrong it was ages ago ) , if its the same as a Marui on...

The Hop is now working , i just need to fettle the printing process and i just got the first Mag Well finished as seen below but I'm still tweaking it...

Its in primer ready for filling , sanding and spraying .

There's very little force on that part , you could probably glue on a small piece of plastic , I can only imagine it broke because someone tried to ta...

Gunna be a proper social

More bits , the front vehicle/anti aircraft mount , another part that goes under the receiver to make it deeper and two side pieces that go on at the ...

No problem

This one is finished , i'll print another for this project as this one has a fault shown in the last pictures , i printed it with an outer shell on th...