i'm using this battery from component shop

Any more news on this? I'm getting close to restarting my M1928 project, and while I have the machinery and material, I'm not relishing the work invol...

For the Ares: Really Nice blow-back action (Big grin factor) Is it a proper "open bolt" type (normally sits back and goes forward during fir...

Another option is the stuff I use on my compensators - I just checked, and it looks the same as my AGM Sten to me. Halfords Grey Primer, then Halford...

Hmmmmm. Looks like a lipo conversion is in my Sten's future.

What about using one of the too glossy ones and wet/dry sanding it flat?

Not so much customs as the weight to ship. Barrel's aren't a problem for those of us with a lathe. The receivers are the biggest issue. And WRT the...

If you're replicating the old MM kit, I'd have one if the price were right. ^ That. Certainly the receiver, at the very least. Seconded. Though you'...

This is a 1-piece receiver, right, not the "glued-together" one some people got from the far east a while ago? If so, I should think there'd...

would it be hard to get into the internals for upgrading or will it be difficalt to take to bits Warren may be able to build it with the upgrades you...

... sorted out my lathe's alignment, and made a part for Graeme's MG34.

I just measured the muzzle nut on my ASG gun. It's an internally threaded tube 15mm long, outside dia. about 20mm before a straight knurl is applied....

It'll be a few weeks before I can get to it, but if they're simple enough, I could have a bash at making some.

ill check my spares box, i may have a spare barrel nut i can send you Having thought about it more, it's actually the MUZZLE NUT that he needs. The ...

Lightweight respirator case, small pack, and large pack. Courtesy of some ferreting by McVickers. Thanks.

ASG MP40 from Warren,