They are. If I don't have one in stock, I can make more to order. PM me.
I know that the wrong upper receiver is on it, but I didn't see anything else wrong with it. You didn't look too far then: To list a few errors: * Wr...
Yes, it can be done. But only if you've got a TM or a KA (like you have). If you've got a Cyma, then its not straight foward and needs some modificati...
Anyone have a spare I could borrow to see if it's copyable?
Ouch, was that shooting at 422 fps? Nothing ten seconds and a pair of pliers to snip a smidge from the hammer spring can't fix though A friend tried...
My source is revealed in this thread: viewtopic.php?f=13&t=11842 The compensator is drawing number 5564369 "COMPENSATOR, RECOIL". What...
I've been over my Sten's barrel with a digital vernier. The barrel outer diameter is 17.3 mm (0.68"). The inner diameter of the main tube is 10 ...
Can't advise on the stock tube type as I use a receiver battery, but I can tell you that ROF will go up, even if you use a 7.4V LiPo, due to the way t...
I've had a look, and there are various tubes available on Ebay, including this one:
Unless the existing barrel could be re-tapped from 12mm+ to 14mm+, or would there not be enough meat left on the barrel ? That's possible. The drill ...
Basically reproducing the AGM barrel. A 16mm OD tube could be found with a suitable wall thickness to put a double-ended M14x1mm adaptor in the muzzle...
Owners of the VIVA STEN are stuffed - no threads at all. But how about this for a simple solution for both STEN types - a replacement outer barrel, si...
Sorry, Arthur, I meant what pipe adaptors did Joker look at. Some of the brake pipe adaptors might be suitable to modify - that would mean I'd not hav...
I've made single-thread adaptors for Uzis, but I've never made double-threaded adaptors before. It'll be an interesting challenge to look forward to. ...
When I'm able, I'll give it a try.
Have been checking various web-sites but can't find a 12mm<>14mm male-to-male adaptor - is it 12mm CCW or CW, btw ? As Poacher said: CW. It'd ta...
My investigation shows the thread on the tip is M12 x 1mm pitch. The thread is about 7.5mm long on the tip, but the muzzle is threaded deeper than tha...
Being a Sten owner and amateur machinist, I'll happily investigate a little for you. However, I can't operate my lathe and mill for a while, as I've j...