needed to re bridge part of the top receiver to form the ejection port , it's subtly bulged to fit over the gearbox but as the rear is butted up again...

Ok I'll go with it ,just looked wrong on the bench but in pictures it looks right .

front lower receiver bracket this part i'm going to weld in place and use as the forward mounting for the rest of the lower receiver .

Russel i just made up a template for the lower receiver to the measurements you gave and again it looks wrong ,its only a cardboard overlay but it doe...

Unfortunately there's no metal above the pistol grip to screw a bolt into except the gearbox and I can't drill holes into it at that point ,it will l...

For the lower receiver I plan on making it in two parts ,just above the rear pistol grip there is a u section outer part that wraps around the front ,...

It would make life a lot easier but i'll leave the desicion for now as I might have a bright idea later on ,I had'nt thought of using the lower receiv...

Finally got back in the workshop today ,had time to blend the welds on the mag well so next is to start the trigger housing trigger and hand grips ,al...

was hoping to get to this one but its just too soon after surgery to risk it ,hope you all have fun.

will book at month's end when there's money again.

Indeed welcome Whatever side you start with remember an infantry impression will be the most versatile and German will get the most action as they tau...

Yes thank's everybody

Hello and welcome

I believe the gearbox is a version 7 ,not a difficult one to work on at all ,have a look on YouTube for a guide .I'm supprised that an air soft shop w...

booking at end of month , can't wait.