Nice job Nick, the wood has a great grain effect. Looking forward to seeing it up close at the game. My own attempt has stalled for the moment, othe...

Put me down for The US 84th, will pay asap. Andy

Found the actual advert in magazine....at last!-- attachment is not available --

Good modification on the hop, I knew this was on one of the posts from Nick, took me some time to find it. I will be doing this today on my sten. Andy

That'll be aeg Max, gas? Don't go there unless you have a lot of patience.

I discovered on the second one, I didn't need to grind off as much as I did with the first one (see pic) both mags fire fine no more bloody wheely, w...

I have discovered that the M14 tappet bar will fit the sten......with a bit of very careful dremel work to make the nozzle fork/ connection fit. I wil...

The head on the left is a stock M4, the left one, Sten, nozzle tube set lower, head is longer, the tappet bar looks very similar to M14 type and a bit...

Stripped down g/box today, typical AGM, a total $¥€%*~?= mess, strangely enough it ran quite well, but I've decided to do a quick spring change conver...

Finished piece,-- attachment is not available ---- attachment is not available --

I second that, the G&G is very good and probably has the edge on cosmetics but the mags can be fiddly to fit at first, but OK with practise. The...

The receiver tube has a cut out that the original handle slides into, so that stops the bolt/cylinder from sliding out, also the spring tension of the...

PM me a postal address, Gordon. I'll put one in the post when finished. Andy

That's a great idea on the mag catch! Total integral mount, no falling out when dissembling! Andy

The k98 charge handle, has a square section from the bolt, 11mm squared, the arm, is thicker to the square, at 10 mm. tapers out to 9 mm, the ball is ...

Got most of the job done, rain stopped play at one time, so will have to finish pieces during the week.....maybe. Cut drilled, threaded, shaped and...