I want to put a few rounds through this, and then check on my cylinder extension design, and if it’s all ok, then I’ll put this up for sale.

At last got back to doing a bit on the Enfield stocks, pushed ahead with the no.5, more as a prototype than anything else, made trigger guard, “rubber...

Haven’t been on here for a while, work had to stop on the Enfield’s as the weather took a turn for the worse, and I’ve just been through the Covid cha...

Work is stacking up!-- attachment is not available --

Rather than make a two section stock as per original, I opted for a one piece because of strength and of course ease of manufacture, I will recess the...

Few more pic’s-- attachment is not available ---- attachment is not available ---- attachment is not available --

I’m just waiting for the wife to discover what I did with her cutting board!

Here’s a couple more pic’s, hop unit re- route, barrel cooling tube fabrication, right side of finished gun.-- attachment is not available ---- attach...

You are correct Anu, G3 receiver, top and bottom, shaved a few bits off here and there, so it still breaks down very much the same as any G3, just hav...

Here’s a pic with no. 2 with no.1-- attachment is not available --

I must admit quite a strange one to do, but it was fun doing it, the hop unit is made from a kitchen cutting board! Using the original hop as well, wi...

Hooray! Here’s another,-- attachment is not available ---- attachment is not available --

Trying again with a Pic, hopefully this will show up,-- attachment is not available --

No, it won’t put up pic’s, just knocks me out of the forum, back to google, I’ll have find another way.

Pic’s didn’t attach,

Ukara is only to cover complete Airsoft guns, It’s not needed for parts, that’s one of the stupid parts of the ruling you could order a complete gun...