Nice work. The muzzle projection looks OK to me. The barrel on my SnS No.4 sticks out about 42mm in front of the sight protector.

I'm an electronics engineer, and MOSFET controllers are in my guns' futures. Another of my roundtuits.

Someone on the Zeroin forum was complaining about it being an old version and added a "WFT?" about the tangent sight. Obviously doesn't kno...

Would this be the one to use to replace an 8.4V mini?

Should the wheel separation be the same as the jeep? If it was, the wheels would follow in the jeep's tracks off-road.

"Grip mount" or "Mount, Grip" ( Drawing 6147676 ). It's not usually listed separately as the barrel would need to come off to rep...

LOL - Looks like a sawn-off FlAK 88 on a shrunk mount!

This page shows a good comparison between all three (Shoot 'n' Scoot's, SoF's & the D.I.Y approach) against real Blanco (both fresh and worn): htt...

The dummy shell could be your "pressure-bearing" part. Solid brass, bored to take the shotgun blank, and vented radially to allow the gasse...

And they STILL don't make a proper M1928.

They should be stored charged, and not let to discharge beyond a certain point.

Does "full metal" actually mean full metal, or is it Cyma's definition of "full metal" (i.e. metal apart from the plastic frame)?

Thanks. The No4 is a bit long for floating about in a soft case.

OT: Zero Bravo: What case is that?

Without checking, I'd say the upper receiver was sheet steel, so it would hold paint well. Equally, if the stock is aluminium, it'd not hold paint at...

M14 motor/gearbox assembly for semi-locking MOSFET experiments.

I should think that repro stocks could be made for airsoft quite easily. A lot, if not all, of the originals were laminated wood - Would be easy to i...