Here it is.... We came to a mid point on the finish, looks close enough but could be better in my eyes. I think the fact we spent £30 making this ad...

Internals are V3 mate.

Why thanks, Bi pod for this one until i get a bi plane that is UPDATE! What can I say, I like big butts. So here's mine! 3mm Ali sheet. Dremel'd an...

Morning everyone. Sorry for the wait but Christmas and Lewis guns have eaten all my spare time The Hop Unit This is the Hop unit. It is a vsr st...

Blimey. Lets see how my first one goes. If it all goes smoothly (does it ever?) I may do a run of them. Problem is if I do too much more airsoft stuff...

Depending on the out come of mine I'd be more than happy to do one for you Ta Dave

Ah fair point, oh well it's done now and it works. If i do another stock I'll bear it in mind. Ta Dave

Ah ok cool. It's ply wood so I don't know if that makes a difference? Ta Dave

Rob and I shaped the stock today with a rasp and power sander. Then gave it some stain and a coat of linseed oil. I've temp mounted it for photo's and...

Did the fins today. could be better but I'll look at improvements later. Ta Dave

I'd have made the centre laminations in 2 parts to form the wiring channel. Already done mate. It's cut into the center sheet that's not shown. will ...

Did some more today. Only had an hour of so to work on it today (with the help of Rob) Anyway, Time for today's update Started on the stock. Scale...

UPDATE Added the sides to the wind mech. Need to put a small winder on the Allen bit. gonna leave a small length of it exposed for quick winding in t...

Cor it's been a while! Bit of an update for you gents.... Got the mag back from the fiberglasser (my mate Matt) and got my support gunner Rob to fill...

at the check out if you use it on the express site you get money off postage too! Ta Dave

Thanks, I have a couple of mosfets sitting around here I've never got around to using so I'll probably pop one of them in it. I may take a cast of the...

Bearing head, Spring guide, nylon piston, 6mm bushings, AR latch gears and shims. Buy from RSOV it's cheaper and Ehobby ALWAYS gets caught for customs...

if you need any help give me a shout. I can also supply a MOSFET if needed. With regards the nozzle you need to use the existing one as it's a mm or t...

Aw thanks I'll deffinately do a guide as I do it and i'll try and include more detail this time. I could have taken lots more photo's last time but...